Wilson Combat® Ultima-Lube II is a blend of petroleum and synthetic lubricants specially formulated to insure optimal performance of any firearm and inhibit wear.

Ultima-Lube II Universal

• All Purpose Lube for All Firearms


• Stays Put Under Extreme Conditions


• Recommended Lube for Wilson Combat® Handguns


• 40° to 350° F Temperature Range


• Recommended for Service Pistols/Revolvers and Broken-In Custom Handguns, Long Guns of All Action Types, AR Style Rifles in the 20° to 50° F Temperature Range

Wilson Combat® Ultima-Lube II is a blend of petroleum and synthetic lubricants specially formulated to insure optimal performance of any firearm and inhibit wear. The unique blend of lubricating fluids has proven ideal for today's high-tech semi-auto weapons, whether manufactured of conventional steels, aluminum alloys or stainless steel. In addition, we have found nothing superior to Ultima-Lube II for the proper lubrication and protection of the hand-fit custom firearms that Wilson Combat® is known for.

Ultima-Lube II is Available in Four Formulations:

Ultima-Lube II Lite Oil - Very low viscosity. Ideal for extreme cold weather use. Recommended Uses: Tightly fitted handguns of minor caliber.

Ultima-Lube II Oil - Thin viscosity penetrates hard to get to areas. Ideal for cold weather use, 10° to 350° F temperature range. Recommended Uses: Tightly fitted handguns of all types.

Ultima-Lube II Universal - All purpose lube for all types of firearms. Stays put under extreme conditions, 40° to 350° F temperature range. Recommended Uses: Service pistols/revolvers and broken-in custom handguns, Long guns of all action types, AR style rifles in the 20° to 50° F temperature range.

Ultima-Lube II Grease - Ideal for heavy wear areas. Stays put under extreme conditions, 40° to 350° F temperature range. Recommended Uses: Full and Semi-Auto rifles and carbines, Optimal in AR style rifles at temperatures above 50° F.

General Recommendations on Lubricating Firearms:

• ALWAYS wear safety glasses when disassembling or reassembling any firearm!


• Do NOT over lube!!!


• Once your firearm is broken in, lube only those areas where you see visible wear, lubricating areas that don't have contact will only attract debris and fouling.


• After lubrication and re-assembly, cycle the firearm several times and wipe off any excess lubricant that may seep out. If you have lubed properly this should be minimal.


• For firearms that will be used at constant temperatures below 10° F, we recommend you use a very light coat of a very thin lubricant like Break Free CLP or FP-10.

Ultima Lube II Universal MSDS

WARNING: This product can expose you to chemicals including petroleum products, which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.