Wilson CombatŪ Ultima-Lube II is a blend of petroleum and synthetic lubricants specially formulated to insure optimal performance of any firearm and inhibit wear.
Ultima-Lube II Lite Oil
Very Low Viscosity, Penetrates Hard to Get to Areas
Ideal for Extreme Cold Weather Use
Excellent for Precision-Fit Firearms
Recommended for Tightly Fitted Handguns of Minor Calibers (9mm, .38 Super, etc.)
Wilson CombatŪ Ultima-Lube II is a blend of petroleum and synthetic lubricants specially formulated to insure optimal performance of any firearm and inhibit wear. The unique blend of lubricating fluids has proven ideal for today's high-tech semi-auto weapons, whether manufactured of conventional steels, aluminum alloys or stainless steel. In addition, we have found nothing superior to Ultima-Lube II for the proper lubrication and protection of the hand-fit custom firearms that Wilson CombatŪ is known for.
Ultima-Lube II is Available in Four Formulations:
Ultima-Lube II Lite Oil - Very low viscosity. Ideal for extreme cold weather use. Recommended Uses: Tightly fitted handguns of minor caliber.
Ultima-Lube II Oil - Thin viscosity penetrates hard to get to areas. Ideal for cold weather use, 10° to 350° F temperature range. Recommended Uses: Tightly fitted handguns of all types.
Ultima-Lube II Universal - All purpose lube for all types of firearms. Stays put under extreme conditions, 40° to 350° F temperature range. Recommended Uses: Service pistols/revolvers and broken-in custom handguns, Long guns of all action types, AR style rifles in the 20° to 50° F temperature range.
Ultima-Lube II Grease - Ideal for heavy wear areas. Stays put under extreme conditions, 40° to 350° F temperature range. Recommended Uses: Full and Semi-Auto rifles and carbines, Optimal in AR style rifles at temperatures above 50° F.
General Recommendations on Lubricating Firearms:
ALWAYS wear safety glasses when disassembling or reassembling any firearm!
Do NOT over lube!!!
Once your firearm is broken in, lube only those areas where you see visible wear, lubricating areas that don't have contact will only attract debris and fouling.
After lubrication and re-assembly, cycle the firearm several times and wipe off any excess lubricant that may seep out. If you have lubed properly this should be minimal.
For firearms that will be used at constant temperatures below 10° F, we recommend you use a very light coat of a very thin lubricant like Break Free CLP or FP-10.
WARNING: This product can expose you to chemicals including petroleum products, which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.
I use Wilsons Lite Oil for two primary purposes and it does its job in typical Wilson fashion.
I have a Spyderco stainless folding knife that locks up as tight as any custom knife I have ever seen. A small drop or two in the locking mechanism keeps the contacts operating as smooth as greased glass.
I also use the Lite Oil to help protect my knives and firearms. With an old-fashioned shaving brush and a few drops of Lite Oil, you can easily and quickly wipe down the exterior of these implements, thoroughly coating them with a thin layer of solid protection.
I also strongly suspect that this lube will be beneficial during the frigid Illinois winters by preventing a slow-down or stoppage caused by heavier lubes.
Wilsons Lite Oil is a fine product and I heartily recommend it.