After several years in development by Wilson Combat Pistolsmiths these all-new, completely oversize barrels will turn even the most inaccurate Glock® pistol into a precision shooting machine!
Constructed of billet aerospace grade 416R stainless and oversize in all fitting dimensions-even the muzzle-these barrels when properly fitted, will shoot groups rivaling a 1911 handgun with a match grade, fully fitted barrel.
Designed for professional gunsmith installation, these barrels will require significant fitting to the barrel tube at the muzzle lockup area, all chamber hood contact surfaces and significant fitting to the lower locking lug. This barrel will not drop in to any firearm without significant fitting.
The Wilson Combat “Full Fit” Glock ® barrel is already completely chambered and finish crowned after being button rifled with a 1-16” twist that stabilizes all common bullet weights for superb all-around accuracy.
Wilson Combat® Match-Grade Pistol barrels are well known for their unsurpassed quality and accuracy and now you can experience a true, target fit in your Gen 3 or Gen 4 Glock ®.
Before you start fitting the Wilson Combat Full-Fit Glock® barrel, be aware that once you remove material the barrel is no longer returnable. When fitting the hood width, length and locking block please go slowly. Once metal is removed it cannot be put back. Do not use a rotary tool or belt sander to fit this barrel.
When finished, your “Full-Fit barrel should have zero play at the muzzle or at the hood but still glide into battery when you cycle the gun. This barrel has been designed so further chamber reaming is unnecessary in most guns.
At this time it is time for test fire. If your slide operation is sluggish in operation it usually means you need more clearance added to your lower locking lug. Inspect all fitted areas for excessive wear or peening and polish high spots as needed.
|Product ReviewsClick here to review this item|
|I was a little hesitant since I had never installed a Full-Fit barrel before but I’m so glad I did. You do not need a lathe. The barrel is only oversize for about 1/2” from the muzzle. You can use sandpaper to reduce the diameter if you need to. My muzzle fit perfectly and I had to reduce the length of the hood which was easily done with a small file. I kept marking it with a Sharpie and kept test fitting removing small amounts of metal until it locked up perfectly with no play. It took about one hour tops. I highly recommend this barrel.|
|- Chris Toth, CO|
|So far, so good, I fit this barrel into a Strike Industries ARK slide. The slide has sharp edges, so while I got the barrel to fit properly, the slide was still leaving fine rings on the barrel. A few more passes to polish it down (and deburr the slide a little) its working great. Not hard to fit at all.|
|- Adam C, CA|