GRIP FORCE ADAPTER, GLOCK®, GEN 1,2,&3


GRIP FORCE ADAPTER, GLOCK®, GEN 1,2,&3
Rated 5/5 based on 1 customer reviews
$26.9500
Item Number: NW366
 Review Average:  
 Number of Reviews: 1
 View ReviewsReview this item
$26.95
Out of Stock
Quantity 


Your Name :
Email Address :   

Detailed Description

The GRIP FORCE GEN 123 ADAPTER was developed specifically for GLOCK's GEN 1, GEN 2, and GEN 3 series of pistols.  It eliminates the drawbacks associated with
permanent modifications to your factory pistol.  The GRIP FORCE GEN 123 ADAPTER mates completely to the back strap of the GLOCK frame, permitting the shooter's hand to conform to the frame in a more secure manner.  This offers more control and allows the shooter to index the pistol on target more efficiently.

*In 2007 and later, GLOCK produced some pistols (in 9mm and .40 caliber), that have
slightly thicker frames than most other GEN 3 pistols.  These frames, which have a
serial number prefix starting with the letter L (i.e. LXX123), are oversized in diameter at the trigger housing pin location.  The GEN 123 GRIP ADAPTER may not fit on these
oversized frames. This is a very small number of frames, and the majority of L Series serial numbered frames have no fit problems whatsoever. 

Package Includes:

1 - Grip Adapter

1 - Smooth Contour Grip Adapter

4 - Rentention Pins

GEN 123 ADAPTERS FIT STANDARD & COMPACT GLOCK FRAMES GEN 1, GEN 2, AND GEN 3 SERIES.

MODELS: 17, 18, 19, 20, 21, 22, 23, 24, 31, 32, 34,35, 37, 38.

MODELS: 20SF, 21SF (W/ USE OF SILICONE ADHESIVE)  

SUB-COMPACT MODELS: 26, 27. 29, 30, 33, 39

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither Wilson Combat, nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.

IMPORTANT NOTE: "All Service and Warranty Issues Must Be Directed To Manufacturer."



 Product ReviewsClick here to review this item
5
Finally!!! changed the grip angle
Finally found an adaptor that changed the grip angle and not the entire circumference of the grip. It comes with two, and I used the flat one without the vertical lines. Installation was simple. Tap the old pin out, get an idea of the length you need with the supplied pin and trim and file accordingly. I did have to sand down the inside of the adaptor a bit so it fits more flush to get the holes aligned. You may think oh its not a drop in. It needs to be tight and have tension on the pin. It is very easy to do, you wont be disappointed. It fits very flush when it is on. I will get more for my other Glocks. Also, the Pachmayr tactical grip sleeve fits over it.
 

You May Also Like