ETM Max Spring/ Follower Kit, .45 ACP
Optimize your existing ETM .45 ACP magazines for heavy duty, hard use with this spring/follower kit.
Our outstanding ETM polymer follower has been paired with the MAX flatwire spring. The heat-treated stainless MAX flatwire construction never gets stressed or over-compressed like a conventional spring and is guaranteed to never require replacement even after high round counts or daily, extreme duty use.
The ETM Max Spring/Follower Kit will retrofit into all existing ETM 8rd 45 ACP magazines and will also convert existing 47 series full size magtubes to 7rd capacity and 47 Series Compact mags to 6 rd capacity.
The ETM Max Spring/Follower Kit will improve reliability in all existing compatible magazines and especially in an extreme service environment. This spring and follower is compatible with all ammunition from light target loads to +P service ammunition.
Fits the following Wilson Combat® Magazines
|#500||1911 Elite Tactical Magazine, .45 ACP, Full-Size, 8 Round, ETM Base Pad|
|#500C||1911 Elite Tactical Magazine, .45 ACP, Full-Size, 8 Round, Lo-Profile Steel Base Pad|
|Product ReviewsClick here to review this item|
|I bought 4 of these to place in one ETM, two Wilson 47D, and one Chip McCormick. Went in flawless in all of my mags but I have this to comment: Im able to fit 8 rounds comfortably in the ETM magazine, Im able to fit 8 rounds in the 47D and CMC magazines. With the ETM magazine Im able to fit a magazine in with a closed slide. Im not able to load a 47D or CMC magazine with a closed slide. I dont know if I should stop loading my 47Ds to 8 round capacity. I wonder if continuing to do this will cause spring fatigue on these Flat-Wire springs. Only time, or the customer service department can tell. So far I havent had any jams or failure to lock the slide with these Springs on my wilson magazines, cant say the same for the CMC magazine. Wilson Combat really is the best!|
|- Kevin, CA|