This fiberglass-reinforced, polymer, shotgun stock provides synthetic-stock durability and is overmolded with rubber for a sure grip every time you grab your gun.
The recoil pad on your stock is attached with two phillips screws. To remove, use a narrow shaft phillps screwdriver. To the tip of the screwdriver, add a bit of lubricant to to prevent tearing of the pad. Pushing down on the top of your pad with your thumb and moving left to right just of center (top and bottom) you will expose a slip in the pad that locates the screws. To avoid tearing the holes in the pad, do not pull the screw head through. Reverse the procedure to install the pad after the installation of the attaching bolt and washer.