.375 SOCOM is a necked-down .458 SOCOM and is capable of pushing a 200-grain bullet at nearly 2,400 fps from an AR-15 platform. The .375 SOCOM has flatter shooting supersonic long range performance than most Big Bore AR rounds with the added ability to shoot heavy bullet subsonic loads.
|Feed Ramps||Purpose Built .375 SOCOM Specific Barrel Extension|
|Finish||Matte Bead-Blasted Stainless|
|Gas Block Seat||.875" Diameter by .900" Length - Dimpled for Set Screw|
|Gas System||Mid Length|
|Material||Stainless Steel, Type 416R, Barrel Grade|
|Muzzle Threads||11/16" x 24|
|Profile||Recon Tactical - Fluted|
|Rifling||1:12, RH, Six Groove, Precision Button Rifling|
Build Kit Includes:
"1.55-1.60" inside rail height required to clear .875 SLR gas block
The .375 SOCOM is an impressive caliber for hunting and defense but in order for the large, powerful cartridge to properly function in an AR certain steps must be followed.
1.) Our .375 barrels are chambered and set to minimum headspace using a PTG chamber reamer. This is the latest generation, improved SOCOM reamer and designed to accept properly sized brass only. After firing, your empty cases may require trimming depending on your chamber dimensions and load. For all sized cases and factory and reloaded ammunition, we suggest using a case/ammunition gauge to check your ammunition’s overall dimensions.
2.) Since our build kits and rifles are set to minimum headspace to allow for slight headspace growth over time, you may have failures to completely chamber or close for several rounds after building your upper. As your chamber burnishes and bolt and locking lug surfaces mate together your SOCOM will start to feed as designed. This is a very powerful cartridge and we have engineered it to have very tight tolerances for long-term safety and reliability. Make sure you use plenty of light oil on all bolt surfaces when breaking in your upper. This will help the locking surfaces mate with your barrel extension.
3.) Make sure you use the proper Extra Power Action spring shipped with your kit. When adjusting your gas block ensure that you have enough gas for proper function. Test your gas block by adjusting your flow to allow lock back on an empty magazine. If your gun locks back on an empty magazine after 3 single-loaded shots it is reliably locking back.
4.) We only use our modified Lancer magazines for best reliability in .375 SOCOM. Unmodified factory magazines will often have issues feeding blunt or round nose bullets. We do not recommend P-Mags or unmodified GI mags in .375 SOCOM.
Click the link below for 7 Round Magazines:
5.) Gas block installation. Our barrels have one dimple for the rear gas block screw. When installing the gas block make sure the rear screw is tight in this dimple before tightening the front screw. You can drill an extra dimple for the front screw with the proper drill for extra security. Before permanently attaching your block with loctite or rocksett ensure that the barrel gas port and the gas block port line up. If your gas port is out of alignment with your block your rifle may short stroke.
6) Gas block adjustment. Follow the instructions with the adjustable block to tune your gas pressure. This is more easily accomplished with the handguard off the rifle. Remove the front adjustment lock screw and adjust your gas valve screw until your bolt locks back on empty with your lowest powered ammunition. Test your gas block by adjusting your flow to allow lock back on an empty magazine. If your gun locks back on an empty magazine after 3 single-loaded shots it is reliably locking back. When tuned to your satisfaction, lock the gas valve screw with the small locking screw.
Get your new barrel in your favorite Armor-Tuff® color with our Armor-Tuff® Barrel Upgrade Now Availbable